my wipers sometimes wont turn on or wont go at unpredictable speeds, or if i press the washer part it will save going for too long and then stop contained by the middle of the windshield, ill own to do it a couple of times until the wipers actually stop at the bottom, what can i do to fix this?
Answers: replace the wiper control board, GMs have a lot of trouble near these. It is right on top under the cover near the wire connector to it.
ex GM tech....i agree next to vince.....locate wiper motor..remove plastic cover(torx screws) don't drop screws...unplug electric wiring..... replace that circuit boad you see. some aftermarket part stores enjoy these...more $$$ at a dealer......virtuous luck
Whats the best mode to change/replace the...
Answers: replace the wiper control board, GMs have a lot of trouble near these. It is right on top under the cover near the wire connector to it.
How do you fix a chip contained...
ex GM tech....i agree next to vince.....locate wiper motor..remove plastic cover(torx screws) don't drop screws...unplug electric wiring..... replace that circuit boad you see. some aftermarket part stores enjoy these...more $$$ at a dealer......virtuous luck
Resolved Questions
- What type of axle grease should I...
- How to replace airbags correctly?
- What could hold cause my backside brakes...
- Rear defogger out of order!?
- Is it ok to run the saloon...
- 1986 Buick Park Ave Electra Part 2?
- How do i replace the clock desk...
- Replacing engine, is 3.8L w/o superchg indistinguishable...
- 97 Cavalier Fuel Injecter Problem?
- 1998 Isuzu Rodeo front windshield wipers ......