if i took a b16A v tec and put high compresion pistons eagle connceting rods and a eagle crank shaft plus skunk 2 cams valve and spring would it be a fast saloon? i know its a stupid qustion but how much of a horse power gain do you think i would seize out of it? and how fast would the vehicle go in recent times giving me an estimate
Answers: every car and engine is diffirent, i dont know how brisk it can be or how much hp youll gain. how much hp do you have immediately? what kinda car is it? what other mods do you own, intake? exhaust? all valid question. b16's are fast and you can draw from some good speed out of it.
those are some pretty righteous mods. You didn't say what compression but no issue. Assuming everything was done correctly and tuned properly i would read aloud a good 20-40hp depending on the grind on the valve, compression ratio and the tuning.
How do I verbs cloth sitting room...
Answers: every car and engine is diffirent, i dont know how brisk it can be or how much hp youll gain. how much hp do you have immediately? what kinda car is it? what other mods do you own, intake? exhaust? all valid question. b16's are fast and you can draw from some good speed out of it.
How do you remove gum from a...
those are some pretty righteous mods. You didn't say what compression but no issue. Assuming everything was done correctly and tuned properly i would read aloud a good 20-40hp depending on the grind on the valve, compression ratio and the tuning.
Resolved Questions
- 1995 Camry (4 cyl) next to 185000...
- My 05 cavalier make a squeaky nouns...
- How far can you drive on a...
- What is Better a Holly Carburator or...
- How do you know if you involve...
- 1984 Buick Lesabre charging problems?
- My vehicle wont start?
- How Do You Disassemble and Clean Fuel...
- Do i stipulation a 33mm socket to...
- How to remove rust from rope wheel?