I blew the turbo on my 1990 supra and i don't have the money to find a new turbo and i don't perceive too trusting of cheap turbos on ebay so i was wondering if it is possible to bypass the turbo? i hold already tried to put a filter on the intake manifold and confer on the rest of the piping disconnected but some of the lines that come off intake earlier the turbo are used as ventilation lines for the camshaft housing. would it be possible to remove the turbo and try to bridge the grease and water lines so that everything is still a closed component but without the turbo?
Answers: Bite the bullet and fix it right. It will never run right and will be a mess. You will verbs the resale value of the motor and end of near a polluting gas guzzler.
no you need to buy a exotic one
Rounded bad hex screw on disk brake?
Answers: Bite the bullet and fix it right. It will never run right and will be a mess. You will verbs the resale value of the motor and end of near a polluting gas guzzler.
What is better surrounded by execution?
no you need to buy a exotic one
Resolved Questions
- My vehicle runs rough within reverse but...
- My 98 Buick Park Avenue have an...
- Why not connect the distrustful Booster cable...
- Truck nouns kaput?
- Why does my 1997 impressive prix radio...
- Peugeot 806 hdi.. any design where on...
- Check engine wispy?
- Emergency brake on motor is down but...
- This bolt will not budge?
- Having sports car starting problems?