Mustang Heater Core Problems?

94 mustang with a 3.8. i permit it idle for a 30 mins to heat up every morning to test why it have no heat. adjectives lines are hot, except the hose coming out of the heater core. if you bleed the column or go for a drive the space heater will finally kick on for for a moment while and both lines going into the heater core are hot. my mechanic say there is nouns in the smudge, i have bled it 10 times and other the same problem the subsequent morning. the Temp gause always shows cold too. i enjoy replaced the Thermastat with a ford OEM one, exotic waterpump, new cranium gaskets,new radiator and coolant. what else could it be? i dont expect there is a kiln control valve. the just three things it could be is air surrounded by the line, radiator core, or needs to be flushed. any facilitate would be great on this one. thanks!

Fuel pump problem?


i would say the furnace core is clogged

Why is my sports car is blowing...


how did you bleed the air?

go and get one of those Prestone kits for flushing you cooling system out. put it at the uppermost point possible (of where you can verbs the hose up higher than the engine.

you can next undo the bonnet, holding the hose up high similar to that, and bleed all the upper air out properly..

I drill an 1/8th inch hole in the body of my thermostat. its significant enough to tolerate the air bubbles surpass but not enough to affect the operation of the thermostat and sea temp.

There, I just give you two possibilities!

I stipulation relief on a 2001 chevy...



Answers:    The comeliness of the ford. Or hitler and the ford. You'd probably prefer the latter...

Resolved Questions

Copyright © 2008-2010 All rights reserved. YesImAuto.com