trying to replace the ignition module on a 2000 neon but I can't figure out how the wiring harness detaches. Seems close to it should just pull bad but I'm leery about forcing it. the old one isn't stock since it's be replaced several times. There's a little red tab that slides horizontally at the very extremity of the connector and I can move it about .25 inch but it didn't seem to issue. My first time trying to do my own repair
If this has been replaced back.What is causing the problem? Yes, the clip is a locking clip that must be removed.
Answers: that little red clip is a lock clip you have to pull it adjectives the way out and then you can unplug the electrics harness
If this has been replaced back.What is causing the problem? Yes, the clip is a locking clip that must be removed.
How to remove a score from my...
Has anyone successfully popped a dent?
If this has been replaced back.What is causing the problem? Yes, the clip is a locking clip that must be removed.
Can anyone give a hand me beside...
Answers: that little red clip is a lock clip you have to pull it adjectives the way out and then you can unplug the electrics harness
If this has been replaced back.What is causing the problem? Yes, the clip is a locking clip that must be removed.
Resolved Questions
- Is vomit poisonous to sports car paint?
- What's going on near my speedometer?
- Forced induction vs. glorious compression pistons?
- After installing a remote starter, we've notice...
- I want to silver my 1970 gtos...
- Help! my vehicle is making strange sounds?
- I own a 95 chrysler cirrus and...
- My vehicle make a coil up hullabaloo...
- Is in attendance a opening to testing...
- Battery Relocation Issue?