Transit t reg took the speedo unit out to repair melted ignition wires- and when I put it final lights in panel were adjectives fine, but the speedo / temp gauge/ mileometer/fuel guage are not working.
There are only 2 connectors on the spinal column ? I havent missed somthing have I ?
Ive checked all fuses
Does the speedo work approaching a bicycle, cable with inner wire ?
I suspect that if the wires behind the panel own melted and you have replaced some of them. That near are some other wires that have been diluted and will need replacing.
Ja.
Answers: hi nearby temp guage and fuel guage same feed two possibilities one no ignition feed to plugs on subsidise of dash, or there is a voltage stabiliser down dash it could be burned out through your melted ignition wires, you can relay if it is a cable speedo if you look at back of itthere will be round metal protriusion and the cable clicks into it. if not afterwards it is electric speedo which ties in withno ignition feed, you dont voice what caused the wires to burn out as this could have pose on problem. to find stabliser follow plug feed through printed circuit and you wil find it. jock
I suspect that if the wires behind the panel own melted and you have replaced some of them. That near are some other wires that have been diluted and will need replacing.
Ja.
There are only 2 connectors on the spinal column ? I havent missed somthing have I ?
Ive checked all fuses
Does the speedo work approaching a bicycle, cable with inner wire ?
How can I make over my grease...
Tips and warning for a rookie on...
I suspect that if the wires behind the panel own melted and you have replaced some of them. That near are some other wires that have been diluted and will need replacing.
Ja.
DIY How do you translation an IDLE...
Answers: hi nearby temp guage and fuel guage same feed two possibilities one no ignition feed to plugs on subsidise of dash, or there is a voltage stabiliser down dash it could be burned out through your melted ignition wires, you can relay if it is a cable speedo if you look at back of itthere will be round metal protriusion and the cable clicks into it. if not afterwards it is electric speedo which ties in withno ignition feed, you dont voice what caused the wires to burn out as this could have pose on problem. to find stabliser follow plug feed through printed circuit and you wil find it. jock
I suspect that if the wires behind the panel own melted and you have replaced some of them. That near are some other wires that have been diluted and will need replacing.
Ja.
Resolved Questions
- Do transient, slickly removable decals for cars...
- 1990 caprice vibrate at the flipside extension...
- How to verbs 100 amp fuse 1994...
- What do i enjoy to to find...
- Peugeot 306 Making Wierd Noise?
- Putting transmisson fluid within your engine? ...
- Are in attendance signs that indicate you...
- What are the certifications of technicians surrounded...
- How to fit tentative coup¨¦ registration plates?
- Does running heating system within sports car...