I have two alpine type e's rated at 250RMS/750MAX. I blew my previous amp a few days ago and granted to get this two channel here: http://www.maaudio.com/product.jhtm?id=1... (yes I know its not the best) because it matched the RMS so resourcefully. My question is in ohms. The alpines are 4ohms, Im wondering do they enjoy to be ran in a special mode to the amp. I mean considering its a two channel amp..cant I a short time ago plug each speaker into its own channel as I did beside the previous 2ohm subs?
No special wiring. Just run one sub off respectively channel.
http://www.crutchfield.com/learningcente...
Good Luck!
Answers: Just wire each sub to respectively channel - done!
That's actually what I did near my system.
No special wiring. Just run one sub off respectively channel.
http://www.crutchfield.com/learningcente...
Good Luck!
Should I attempt to install my trial...
No special wiring. Just run one sub off respectively channel.
http://www.crutchfield.com/learningcente...
Good Luck!
Problem getting the Sound system contained by...
Answers: Just wire each sub to respectively channel - done!
That's actually what I did near my system.
No special wiring. Just run one sub off respectively channel.
http://www.crutchfield.com/learningcente...
Good Luck!
Resolved Questions
- Subwoofer amp setting press?
- What do you contemplate roughly my amp...
- Car Amp problem - Power Protect...?
- Kicker vs. Memphis vs. MTX vs. Alpine...
- Car Audio Install?
- Hifonics Titan TX1005D?
- What type of hydraulics are used for...
- Tapping into stereo electric wiring harness?
- Is a indash dvd form my truck...
- Deck Install Problems?