I am buying a stereo system for my car. So, If I buy one 1000 watt Sub, after do I need 1000 watt amp or smaller quantity wattage??
And If I buy 2 1000 watt Subs, then can I still use a 1000 watt amplifier??
Also, What sounds the best, 2 10 inch subs, or one 12 inch 1000 watt??
Thank you!!
(Once I know I will dance to ebay right now and buy, I want to know what wattage and stuff)
Okay you just dont want your MAX amp output to pass by your MAX sub output by too much. 10% is a guideline for no more than that excedance.
RMS is key.
Its the nominal power
Youd resembling your amp to be close to your subs RMS for good ratio and to fade overheating and overpowering/underpowering
ok for example:
2 12" subs that are dual voice coils
1000 watts / 300 rms
adds up to be 2000 watts 600rms
for this you inevitability a amp that goes around in that if you get one explicitly smaller then you run the risk of over heat the amp
as far as the 10" or the 12" it depends on the watts that the 10" can handle and if you really stipulation the trunk space there are ten inch subs that hit as strong as 12" but it all depends on what you want and when if you buy the amp first you shood win subs according to the rms not the watts
Answers: There's no good agency to compare subs just base on the size of the cone.
10" is usually more crisp than 12", whic is more crisp than 15"
However,
15" is usually deeper and louder than 12" which is deeper and louder than 10"
If you've never had subwoofers formerly, I suggest you get yourself 1 12" sub rate for approximately 300 watts RMS, and find an amp that can do that as well.
Check the resistance on the sub, find one that is to say 4 ohm. Then, pick out a Class A Stereo amp that is "stable at 4 ohm bridged" for 300 watt rms. It should be plenty.
It's also essential to pick the right sub. Ask around and see what subs are good for you to get hold of. Punch subs by Rockford Fosgate have other been a angelic starter sub.
And for some more of the technical stuff, if you own 1 sub that is rate for 400 watts rms, then you should buy an amp rate for 400 watts rms. If you have 2 subs that are rate for 400 watts rms, then you're going to own to step it up and buy a sub that is 800 watts rms, or 400x2 watts rms.
Hope this help.
Ok I could go on and write 2 or 3 page on this. But I would recommend for you to go to a store pretend approaching you are really gonna buy something and try stuff out then when you close to something gt the models ( amp and subs) then step to eBay and buy them there CZ you will find it route cheaper Plus stores always want to stick you beside something that you might not need or that its more expensive flawless luck
And If I buy 2 1000 watt Subs, then can I still use a 1000 watt amplifier??
Also, What sounds the best, 2 10 inch subs, or one 12 inch 1000 watt??
Thank you!!
(Once I know I will dance to ebay right now and buy, I want to know what wattage and stuff)
Is it surrounded by anyway possible to...
Okay you just dont want your MAX amp output to pass by your MAX sub output by too much. 10% is a guideline for no more than that excedance.
RMS is key.
Its the nominal power
Youd resembling your amp to be close to your subs RMS for good ratio and to fade overheating and overpowering/underpowering
ok for example:
2 12" subs that are dual voice coils
1000 watts / 300 rms
adds up to be 2000 watts 600rms
for this you inevitability a amp that goes around in that if you get one explicitly smaller then you run the risk of over heat the amp
as far as the 10" or the 12" it depends on the watts that the 10" can handle and if you really stipulation the trunk space there are ten inch subs that hit as strong as 12" but it all depends on what you want and when if you buy the amp first you shood win subs according to the rms not the watts
Answers: There's no good agency to compare subs just base on the size of the cone.
10" is usually more crisp than 12", whic is more crisp than 15"
However,
15" is usually deeper and louder than 12" which is deeper and louder than 10"
If you've never had subwoofers formerly, I suggest you get yourself 1 12" sub rate for approximately 300 watts RMS, and find an amp that can do that as well.
Check the resistance on the sub, find one that is to say 4 ohm. Then, pick out a Class A Stereo amp that is "stable at 4 ohm bridged" for 300 watt rms. It should be plenty.
It's also essential to pick the right sub. Ask around and see what subs are good for you to get hold of. Punch subs by Rockford Fosgate have other been a angelic starter sub.
And for some more of the technical stuff, if you own 1 sub that is rate for 400 watts rms, then you should buy an amp rate for 400 watts rms. If you have 2 subs that are rate for 400 watts rms, then you're going to own to step it up and buy a sub that is 800 watts rms, or 400x2 watts rms.
Hope this help.
The audio surrounded by my '03 honda...
Ok I could go on and write 2 or 3 page on this. But I would recommend for you to go to a store pretend approaching you are really gonna buy something and try stuff out then when you close to something gt the models ( amp and subs) then step to eBay and buy them there CZ you will find it route cheaper Plus stores always want to stick you beside something that you might not need or that its more expensive flawless luck
Resolved Questions
- What does "ASL" penny-pinching on my saloon...
- What audio setup?
- What amp should i draw from to...
- How do i hook up an amp...
- How much Power is too much power?
- Wats da best setup i can achieve...
- Removing radio within 1997 Saab 9000 PLEASE...
- TomTom bought from USA?
- I hold 2 10'' subs, connected to...
- Lift tools or speakers first?