i bought a bulk pack of dynamat extreme and im planning on installing it myself... are there any special tools i should buy for the install?
Answers: You might want to procure a small roller and wear cut resistant gloves. The metal backing will cut the sh(a)$ out of you. Its best to do on a hot time. Measure and cut your pieces then check out of them in the sun for give or take a few 5 minutes. Then apply to a clean dry surface. You can use your fingers to work it into the gaps(or the roller). If you really want to lose rattle, get silicone base caulk and some latex gloves and anywhere 2 pieces of metal have a small gap(on the trunk lid) put a bead of caulk contained by the gaps and work it within with your finger(use rubber gloves). Any big cavity shove owens corning type insulation into. And dynamat the back of your license plate. These tips should grasp rid of all rattle
the hardest part is pulling sour all the plastic trim and door panel... just use a flat tip screw driver to practically pry the door panels sour. You will also need a socket set to verbs the seats out. Just bear your time and try not to break anything. They do sell a special tool to remove the door panel but I just use a flat tip screw driver.
Answers: You might want to procure a small roller and wear cut resistant gloves. The metal backing will cut the sh(a)$ out of you. Its best to do on a hot time. Measure and cut your pieces then check out of them in the sun for give or take a few 5 minutes. Then apply to a clean dry surface. You can use your fingers to work it into the gaps(or the roller). If you really want to lose rattle, get silicone base caulk and some latex gloves and anywhere 2 pieces of metal have a small gap(on the trunk lid) put a bead of caulk contained by the gaps and work it within with your finger(use rubber gloves). Any big cavity shove owens corning type insulation into. And dynamat the back of your license plate. These tips should grasp rid of all rattle
Is a GPS navigation system any perfect?
the hardest part is pulling sour all the plastic trim and door panel... just use a flat tip screw driver to practically pry the door panels sour. You will also need a socket set to verbs the seats out. Just bear your time and try not to break anything. They do sell a special tool to remove the door panel but I just use a flat tip screw driver.
Resolved Questions
- Should I go and get JL audio...
- My car's disc player will not eject...
- Why is here a HIGH HISSING uproar...
- Is it possible to replace my factory...
- What is a honourable amp for 2...
- Car stereo adapter. honda to pioneer?
- Which subwoofers are better?
- 1ohm electrical system please minister to !!?
- How does a vehicle audio amplifier work?
- Using a coup¨¦ stereo..in need the coup¨¦..?