Im hooking up speakers tomorrow in my vehicle i know how to do everything except two things....
1. how to use butt connectors
2. where to put my crossovers (i meen i dont enjoy long wire so where on earth does it go [[i hope its not the trunk]]). Cause thats meens self have to lift out the backseat and everything.
..btw if this helps i own the Kicker KS6.2
Answers: You can put the cross overs at the speakers. Use the factory speaker wire as the input to the crossover after run the mid and tweeter out from the x-over to the speakers. Be sure to check the mounting point for the x-over so it doesnt interfere with the skylight rolling up and down. If you mount it inside the door cavity be sure to waterproof it. I across the world mount them between the door panel and the door.
you can run the cross-overs near the speakers, but you still hold to run the input line wager on to the amp on each one. as for butt connectors. hehehe, put one flex in crimp it, put grill shrink tubing over it, put the other wire within, crimp it, slide the heat shrink over the full thing and roast to perfection. (i would only recommend this if soldering is not an option)
1. how to use butt connectors
2. where to put my crossovers (i meen i dont enjoy long wire so where on earth does it go [[i hope its not the trunk]]). Cause thats meens self have to lift out the backseat and everything.
..btw if this helps i own the Kicker KS6.2
Home theater sub contained by a truck?......
Answers: You can put the cross overs at the speakers. Use the factory speaker wire as the input to the crossover after run the mid and tweeter out from the x-over to the speakers. Be sure to check the mounting point for the x-over so it doesnt interfere with the skylight rolling up and down. If you mount it inside the door cavity be sure to waterproof it. I across the world mount them between the door panel and the door.
you can run the cross-overs near the speakers, but you still hold to run the input line wager on to the amp on each one. as for butt connectors. hehehe, put one flex in crimp it, put grill shrink tubing over it, put the other wire within, crimp it, slide the heat shrink over the full thing and roast to perfection. (i would only recommend this if soldering is not an option)
Resolved Questions
- Will two orion hcca 10.2 hit...
- HIFONICS BXi2607D, any upright? stipulation warning from...
- Any compatibility issues between Head Unit from...
- My motor stereo is messing up bleak...
- What is the difference from have your...
- How do i install a capacitor to...
- How do I hook up my amp...
- Remote start added to my existing viper...
- Which speakers are best for motor out...
- What size are the door speakers within...