'05 Dodge push problems. when i'm within gear and on the brake the truck rocks. what's wrong?

A hard "body moving rock"

TATA NANO surrounded by gone mitt drive?


I'm going to assume it's when you are slowing down and not at a complete stop.

Your brake rotors are causing the problem. The run out on the rotors is out of tolerance. In other words they are bitter. It happens closely on trucks and SUV's.

You can try to have them machined but you will probably own to replace them. That will also mean brand new brake pads as resourcefully. You don't want pads that aren't smooth on unmarked rotors. You'll groove the rotors and end up beside the same problem adjectives over again.

This usually happens by getting the brakes over heated. That can come to pass sometimes and you don't even realize it. It can also happen if you be driving and the rotors are hot then you appendage up in a vehicle wash..........bam they are perverse. A puddle or some other such thing can do it too. Even driving into a rainstorm can contribute.

I'm just about to pick up a...


Perhaps it have a performance camshaft installed.

Is the stand still rpm properly set?

Can you swap an honda engine next...



Answers:    that would indicate a sever miss-fire or a broken mount surrounded by the truck,if it only does it within gear id be looking at mounts or a engine miss-fire near it,good luck.

My saloon quits when you come to...


Either an injector =coil or possibly torque converter lock up going bad pocket to the dealer as that yr have 7=70 warranty> Might be covered>>

Resolved Questions

Copyright © 2008-2010 All rights reserved. YesImAuto.com