but its my first time, so can i anybody give me some suggestion on how to do it so i don't f*ck up
its an '89 acura integra
Answers: you probably will need a phillips screw driver or possibly a star screw driver (I work for NAPA AUTO PARTS). I think the size of the star screw driver is a T-15... hold your time, its pretty self explanitory. If you're not sure, drive to the nearest NAPA or Auto Zone and ask for help, usually they will amendment it for you without trouble.
Are you replacing desk light blubs? Or are you replacing tail light assemblies?
In any case you'll want to pinch out the particular muted assembly. You'll need adjectives sockets. They are sold at hardware stores for about $4 dollars respectively. I think you'll stipulation 8mm deep sockets.
In the trunk, move the covering to the side, be placid so that you don't damage the plastic tab that hold the covering in place. Locate the put a bet on of the light assembly and wth the vast sockets, remove the 4 bolts that hold the tail light assembly contained by place. Unplug the wiring harness (hold down the tab and pull), later remove the assembly.
If you are replacing the assemply itself, then simply install the untried one, making sure the thin rubber gaskets are installed (use newer ones if you can). This rubber gasket is outstandingly important since this is the piece that keep water from leak into your trunk. Tighten the 4 bolts and replug the wiring harness and away you travel.
If you are changing the bulbs, remove the assemply as earlier; but now you'll enjoy to push in a tab and verbs each bulb out and replace it next to new ones.
Good luck, enjoy fun.
its an '89 acura integra
1967 Impala Fender Lights/Corner Lights?
Answers: you probably will need a phillips screw driver or possibly a star screw driver (I work for NAPA AUTO PARTS). I think the size of the star screw driver is a T-15... hold your time, its pretty self explanitory. If you're not sure, drive to the nearest NAPA or Auto Zone and ask for help, usually they will amendment it for you without trouble.
I'm looking for a compact suv or...
Are you replacing desk light blubs? Or are you replacing tail light assemblies?
In any case you'll want to pinch out the particular muted assembly. You'll need adjectives sockets. They are sold at hardware stores for about $4 dollars respectively. I think you'll stipulation 8mm deep sockets.
In the trunk, move the covering to the side, be placid so that you don't damage the plastic tab that hold the covering in place. Locate the put a bet on of the light assembly and wth the vast sockets, remove the 4 bolts that hold the tail light assembly contained by place. Unplug the wiring harness (hold down the tab and pull), later remove the assembly.
If you are replacing the assemply itself, then simply install the untried one, making sure the thin rubber gaskets are installed (use newer ones if you can). This rubber gasket is outstandingly important since this is the piece that keep water from leak into your trunk. Tighten the 4 bolts and replug the wiring harness and away you travel.
If you are changing the bulbs, remove the assemply as earlier; but now you'll enjoy to push in a tab and verbs each bulb out and replace it next to new ones.
Good luck, enjoy fun.
Resolved Questions
- Why does my AIR BAG neutral stay...
- Wierd stuff beside the saloon?
- New 600+ HP ZR1 Corvette, really, what’s...
- I enjoy a volkswagen polo (03) and...
- Would it be feasable to buy a...
- Ford ranger engine?
- Chevy LT1 engine?
- Where can i find an anti-spin reverse...
- Which is the best sports car?
- 1996 Ford Contour idling/stalling cross-question...?