Can I assume the car have ABS brakes since the fuse slots are there? If I put fusses surrounded by the slots, what's the worst that could happen as a result?
Answers: You did not mention the year but on rash 90's Mazda's ABS was not standard equipment. When you turn on the switch there will be a bulb check for the ABS night light. If it lights up you have ABS. If it flashes after you start the saloon and then go out the ABS is functioning properly. If the abs light flashes and after stays on you have a fault. If you want to know for sure you can tell if the vehicle have ABS by looking at the brake master cylinder. A mechanic would most likely do this for free since it solitary takes a minute to verify. And to answer your quiz it would not hurt anything to slide in the proper size fuses to tryout. If the system has a short the fuse will blow. Maybe someone pulled the fuse because the pale was staying on?
Just because the slot is in attendance doesn't mean the vehicle has ABS, and I'm sure if it did the fuse would hold been installed
I am decide between a 2008 scion...
Answers: You did not mention the year but on rash 90's Mazda's ABS was not standard equipment. When you turn on the switch there will be a bulb check for the ABS night light. If it lights up you have ABS. If it flashes after you start the saloon and then go out the ABS is functioning properly. If the abs light flashes and after stays on you have a fault. If you want to know for sure you can tell if the vehicle have ABS by looking at the brake master cylinder. A mechanic would most likely do this for free since it solitary takes a minute to verify. And to answer your quiz it would not hurt anything to slide in the proper size fuses to tryout. If the system has a short the fuse will blow. Maybe someone pulled the fuse because the pale was staying on?
Which Pontiac Model is fastest out of...
Just because the slot is in attendance doesn't mean the vehicle has ABS, and I'm sure if it did the fuse would hold been installed
Resolved Questions
- Speed sensor on 2000 ford ranger.?
- 89 Camaro 2.8 V6 Vacuum Problem?
- BMW grease put somebody through the mill?
- I want to engineer my Mercedes E-500...
- Scion TC, Mazda 3 or Toyota Prius?...
- 06 Town Country Van, Speedo Cluster Question.?
- Why don't I hold +12v to my...
- Heater within 2001 Ford Focus blowing cold...
- FJ Cruiser or something else?
- What glib things can I do to...